PUNCHING
Punch Pressure: 192 tons.
Quick Change Punch Holder and Jog Mode
Punch Work Table: Includes back gauge and adjustable stops.
Adjustable See-Through Punch Stripper: For fast and easy setup.
Die Holder: Adjustable in machined T-slots for quick punch and die alignment.
Standard Tooling: 1-1/2” in 1-1/2” material.
CPD Series: 26 punch, 62 die.
Large Tooling: 2” in 1-3/16″
CPD Series: SP51P punch, SP80D die
Optional Oversize Tooling: 4-5/16” in 1/2” material.
Throat Depth: 24-9/16”
Stroke Length: 3-1/8”
Cycles per Minute in 3/4”: 22
Punching Station Work Height: 44-1/2”.
FLAT BAR SHEARING
Flat Bar Shear Capacity: 16” in 1”.
Maximum Width x Thickness: 24” in 3/4”.
Lower Blade: Four (4) usable edges.
Support Table: Includes guides for accurate positioning and indicator lines at 30 and 45 degrees left and right.
Adjustable Hold-Down: Holds work piece securely in position when shearing.
Upper Shear Blade: Provides for minimum distortion. Two (2) usable edges.
Blade Length: 24”.
Angle Flange Trim: 5” in 5/8”.
Flat Bar Shear Work Height: 37”.
ANGLE SHEARING
Maximum Capacity – 90 degrees: 8” x 8” x 3/4”.
Maximum Capacity – 45 degrees: 3” x 3” x 3/8”.
Shearing with no material loss and minimum deformity.
Shear Blades: Four (4) usable edges.
Angle Shear Work Height: 44-1/2”. |
BAR SHEARING
Round Bar Capacity: 2-1/4”.
Square Bar Capacity: 2” x 2”.
Six Cavity Round and Square Bar Shear Sizes: Round 3/4,1″,1-1/8″,1-1/2″,2″
Square 1″, 1-1/2” to 2-1/8”
Channel Shear Max. (optional): 10″.
I-Beam Shear Max. (optional): 10”.
Bar Shear Work Height: 44-1/2”.
NOTCHING
Rectangular Notcher: 2-3/8” x 4” x 5/8”.
Electrical Interlock Safety Guard
Gauge Table with Stops: For precise positioning.
Notcher Work Height: 36-1/2”.
OTHER STANDARD EQUIPMENT
Five (5) Sets of Punches and Dies:
Punches: 9/16”, 11/16”, 13/16”, 15/16”, 1-1/16”
Dies: 19/32”, 23/32”, 27/32”, 31/32”, 1-3/32”
CPD Series: 26 punch, 62 die
Magnetic Base Work Light
Adjustable Electrical Back Gauge (39”)
24 Volt DC Control Voltage
Scrap Boxes at Punching and Notching
Stations
Adjustable Stroke Depth at Punch
Two (2) Full-Control Foot Pedals
Two (2) Hole Die Holder|
Two (2) Piece Gauging Table at Punch Station
Table comes with 39” X axis gauge
Keyed Punch Holder for Shaped Tooling
Standard Voltage 230/460 Volt, 3 Phase, 60Hz
Single Phase Machines: Not Available.
Machine Net Weight: 13,200 lbs.
Machine Dimensions: 93” L x 38” W x 90” H
|